536 146 243KB
English Pages 17
TAKE OFF
PF
2.TAKE OFF RUN
1.TAKE OFF INITIATION AND POWER SET
3.ROTATION
4.THRUST REDUCTION
PNF
5.ACCELERATION
ACCEL ALT
F
6.AFTER TAKE OFF
S
THR RED ALT L/G UP POWER
80 kt
100 kt
V1
VR
A320 - Version 06d
PF
PNF 1. TAKEOFF INITIATION AND POWER SET
ANNOUNCE………………………….….”TAKE OFF”
CHRONO……………………………………......START
BRAKES………..…………………………...RELEASE THRUST LEVERS… … 1) From IDLE to 50 % N1 (1.05 EPR) … 2) From Both engines THR stabilized to T/O THR
¾ ECAM SD auto - switching
WHEEL
¾ Computer inhibits warnings and cautions.
ENGINE
T.O. INHIBIT
CHRONO……………………………………...START
PF
PNF 2. TAKEOFF RUN
ANNOUNCE FMA…………………………………….
FMA…………………………………………. CHECK ANNOUNCE…………………………..”CHECKED”
N1(EPR)……………………………………..CHECK BEFORE 80 kt
ANNOUNCE…………………….…”POWER SET”
AT 100 kt
ANNOUNCE………...”ONE HUNDRED KNOTS”
ANNOUNCE…………………………...”CHECKED”
PF
Limit
PNF SAME SPEED INDICATION
Limit
80 kt
100 kt
PF
PNF 3.a. ROTATION
AT V1
ANNOUNCE……………………….………..”V1”
At VR
ANNOUNCE…………………..….…”ROTATE”
ROTATION………………………………..PERFORM WHEN V/S positive and RA positive
ANNOUNCE…………...….…”POSITIVE CLB”
ORDER……………………………..…...”GEAR UP” L/G……………………………………….……..UP ANNOUNCE……………………..…”GEAR UP” GRND SPLR…………………………....DISARM EXTERIOR LIGHTS……………………..…..SET ORDER…………………………..”AUTOPILOT ON” A/P………………………..…...ON (on PF SIDE) ¾ AP is available 5 sec after lift off (100 ft). L/G UP 10
10
VR 80 kt
100 kt
V1 Note: With CFM engines, IGNITION is displayed only if IGN/START mode has been selected.
PF
PNF 3.b. PRESELECTED HEADING
ANNOUNCE FMA ……………………....”AP 1 (or 2)”
FMA………………………….………..…..CHECKED ANNOUNCE……………………………”CHECKED”
If RWY TRK mode is engaged: HDG…………………………………PULL or MANAGE
¾RWY TRK mode keeps the aircraft on the runway track memorized at 30 ft RA.
Pull HDG Knob To maintain runway HDG
Or
Push HDG Knob: NAV mode is engaged
PF
PNF 4. THRUST REDUCTION
FMA When LVR CLB flashing on FMA THRUST LEVERS………………………………....CL
FMA If takeoff was performed with packs off: PACKS 1 and 2 …………….………...……….ON ¾ 1500 ft AGLor 2 min after lift off : T.O. INHIBIT
L/G UP
THR RED ALT
¾ ECAM SD auto – switching :
VR ENG
CRZ
PF
PNF 5. ACCELERATION
At acceleration altitude
FMA At F speed with positive speed trend ANNOUNCE…………..”SPEED CHECKED”
ORDER……………………………...…”FLAPS 1”
FLAPS 1………………………………SELECT CONFIRM……………….…………“FLAPS 1” At S speed with positive speed trend ANNOUNCE……….....”SPEED CHECKED”
ORDER……………………………...…”FLAPS 0”
FLAPS 0…………………………...…SELECT CONFIRM………………………... “FLAPS 0”
THR RED ALT
ACCEL ALT
F
S
¾ Target speed change 1st CLB SPD CLIMB phase
V2
PF
PNF 6. AFTER TAKEOFF
APU BLEED/MASTER SW…..…….AS RQRD
ENG MODE SEL…………………….AS RQRD
TCAS…………………………………..…TA/RA
ANTI ICE……………...……………...AS RQRD
PF
PNF 7. TRANSITION ALT
At transition altitude : ANNOUNCE……………………….”PULL STANDARD” BARO REF ...……………......……...PULL STANDARD
BARO REF ...……………...……….…PULL STANDARD ANNOUNCE...……..”STANDARD CROSS-CHECKED”
ANNOUNCE…………………....”PASSING FL XX, now” ALT ...…………….....………………………….….CHECK ANNOUNCE………………………….….….”CHECKED”
AFTER T/O CLIMB C/L
PF
PNF
THE END...
PF
PNF 2. TAKEOFF RUN
ANNOUNCE FMA……………………………………. Typical Typical announcement announcement is is ::
FMA…………………………………………. CHECK ANNOUNCE…………………………..”CHECKED”
“MAN TOGA (or MAN FLX XX), SRS, RWY, A/THR blue” N1(EPR)……………………………………..CHECK BEFORE 80 kt
ANNOUNCE…………………….…”POWER SET”
AT 100 kt
ANNOUNCE………...”ONE HUNDRED KNOTS”
ANNOUNCE…………………………...”CHECKED”
PF
Limit
PNF SAME SPEED INDICATION
Limit
80 kt
100 kt
PF
PNF 3.a. ROTATION
AT V1
ANNOUNCE……………………….………..”V1”
At VR
ANNOUNCE…………………..….…”ROTATE”
ROTATION………………………………..PERFORM WHEN V/S positive and RA positive
ANNOUNCE…………...….…”POSITIVE CLB”
ORDER……………………………..…...”GEAR UP” ¾ ¾ Set Set NOSE NOSE and and RWY RWY TURN TURN OFF OFF lights lights switches switches to to OFF OFF ¾ ¾ LAND LAND lights lights should should be be left left ON ON
L/G……………………………………….……..UP ANNOUNCE……………………..…”GEAR UP” GRND SPLR…………………………....DISARM EXTERIOR LIGHTS……………………..…..SET
ORDER…………………………..”AUTOPILOT ON” A/P………………………..…...ON (on PF SIDE) ¾ AP is available 5 sec after lift off (100 ft). L/G UP 10
10
VR 80 kt
100 kt
V1 Note: With CFM engines, IGNITION is displayed only if IGN/START mode has been selected.
PF
PNF 4. THRUST REDUCTION
FMA When LVR CLB flashing on FMA THRUST LEVERS………………………………....CL THR THR RED RED ALT ALT ~~ 1500 1500 ft ft AGL AGL is is the the default default value value of of the the FMS, FMS, ItIt can can be be modified modified by by the the pilot pilot as as required required by by the the procedure procedure
FMA If takeoff was performed with packs off: PACKS 1 and 2 …………….………...……….ON ¾ 1500 ft AGLor 2 min after lift off : T.O. INHIBIT
L/G UP
THR RED ALT
¾ ECAM SD auto – switching :
VR ENG
CRZ
PF
ONE PACK
PNF
4. THRUST REDUCTION ¾ Do not select PACK 1 ON before reducing Takeoff Thrust, otherwise :
FMA When LVR CLB flashing on FMA
EGT
THRUST LEVERS………………………………....CL ¾
FMA Second pack selection is delayed until clean configuration. ONE PACK……………………...………………….ON • It may be selected earlier, in order to avoid ECAM caution activation, •
but not earlier than 10 seconds after PACK 1 ON, for passenger comfort ¾ 1500 ft AGLor 2 min after lift off :
¾ If
Above 1500 ft L/G UP
THR RED ALT
AIR PACK X T.O. OFFINHIBIT
¾ ECAM SD auto – switching :
VR ENG
CRZ
PF
FLAPS
PNF
5. ACCELERATION At acceleration altitude
FMA ¾ For T/O inspeed CONFtrend 1+F minimum flap retraction speed “F” is not displayed. At F speed with positive ANNOUNCE…………..”SPEED CHECKED”
ORDER……………………………...…”FLAPS 1”
FLAPS 1………………………………SELECT CONFIRM……………….…………“FLAPS 1” At S speed with positive speed trend ¾ When CONF 1+F is selected, auto retraction of flaps to CONF 11 occurs at 210 kt ANNOUNCE……….....”SPEED CHECKED” ORDER……………………………...…”FLAPS 0” FLAPS 0…………………………...…SELECT CONFIRM………………………... “FLAPS 0” 2ND PACK………………………………….ON ¾ Announce “FLAPS X” as soon as the proper position has been selected THR RED ALT
ACCEL ALT
F
S
¾ Target speed change 1st CLB SPD CLIMB phase
V2
PF FLIGHT PHASE SWITCHING CONDITIONSPNF 5. ACCELERATION At acceleration altitude
FMA At F speed with positive speed trend Preflight
Take Off
Climb
ORDER……………………………...…”FLAPS 1”
Cruise
Des
Approach
Go Around or Done
ANNOUNCE…………..”SPEED CHECKED”
FLIGHT PHASES
OPTIMUM SPEED PROFILE
SWITCHING CONDITIONS TO NEXT PHASE FLAPS 1………………………………SELECT
PREFLIGHT
/
SRS take off mode engaged and
At S speed with positive speed trend
N1> 85% (EPR >= 1.25) or CONFIRM……………….…………“FLAPS 1” Ground Speed > 90 kt
V2 (V2 + 10)
TAKE OFF
At acceleration altitude or by engagement of another vertical mode
ANNOUNCE……….....”SPEED CHECKED”
ORDER……………………………...…”FLAPS 0”
Reaching cruise FL FLAPS 0…………………………...…SELECT
CLIMB
ECON CLB SPD / MACH
CRUISE
ECON CRZ MACH
CONFIRM………………………... “FLAPS At descent initiation (if distance to DEST0” < 200 NM and no step descent)
2ND PACK………………………………….ON - Over flying (DECEL) pseudo waypoint with NAV (or DESCENT
THR RED ALT
ACCEL ALT
ECON DES MACH / SPD
F
S
APPROACH
Vapp (GS Min)
GO AROUND
Vapp or current SPD whichever is greater. Green Dot at ACC ALT
CLIMB phase
DONE
LOC*/LOC) mode engaged and altitude < 7200 ft AGL - Manual activation of the approach phase.
¾ Target speed change
1. To Go Around : when thrust levers at TO.GA detent or 2. To Done: 30 seconds after landing or 3. To Climb: when inserting a new CRZ FL
1. To Approach : Manual activation of the approach phase or 1st CLB SPD 2. To Climb: Above acceleration altitude by - Selecting ALTN or - inserting NEW DEST and CRZ FL
V2
/
To preflight when INIT or PERF key depressed
PF
PNF 6. AFTER TAKEOFF
APU BLEED/MASTER SW…..…….AS RQRD
ENG MODE SEL…………………….AS RQRD
TCAS…………………………………..…TA/RA
ANTI ICE……………...……………...AS RQRD
Select Select :: ¾ ¾ APU APU BLEED BLEED to to OFF, OFF,
¾ ¾ IGN, IGN,
ifif APU APU
has has been been used used during during T/O T/O
in in case case of of
severe severe turbulence turbulence or or heavy heavy rain rain
¾ ¾ TA/RA, TA/RA,
ifif TA TA
has has been been used used during during T/O T/O
¾ ¾ ENG ENG ANTI ANTI ICE, ICE,
in in case case of of
expected expected icing icing conditions conditions